Releasing and then holding the power button again decreases the brightness. Initially, holding the power button increases the brightness. When the power is on, holding the power button alternately increases or decreases the brightness. The brightness can also be changed using just the power button. When the power is on, holding the down or up button decreases/increases the brightness. If Fade is enabled, the light is faded on/off at the rate defined by the Speed setting. If the toggle turns the power on, the light is returned to the last brightness it was set to. Pressing and releasing the power button toggles the power on/off. For single-button devices or multi-button devices with remote device mode enabled, only the operations controlled by the power button in the instructions below apply. The SD0x dimmer from Martin Jerry, Acenx, Tessan or NTONPOWER is an example of such a device.Īny other device with one or more buttons, such as any typical Tasmota-capable wall switch, can make use of the PWM Dimmer module to control the power, brightness and light channels of one or more device groups. They typically have power, up and down buttons, a powered-on LED, five brightness LEDs and another status LED.
The brightness of the load for PWM dimmers is controlled by a PWM GPIO pin.
PWM Dimmer module adds support for PWM dimmer switches and devices with one or more buttons that control devices in a device group. To enable PWM dimmer operation, select the PWM Dimmer module. PWM dimmer is supported in standard tasmota.bin
0 kommentar(er)
